MDT Tablet app updates are completed through the Updater app while the tablet is connected to Wi-Fi. The steps to connect to Wi-Fi and complete updates are listed in this article.
Tip! You can identify an MDT tablet by the serial number, which always begins with 730.
Note: Before completing updates, make sure the driver is OFF DUTY and signed out of the ELD Complete App. Completing updates while a driver is signed in could result in the loss of log data.
Updating Apps
To Update Apps on the Tablet
Remove the tablet from the dock.
From the Home screen of the tablet, tap on Settings to access your tablet settings.
Enter the settings menu password: gpsield and tap OK.
Tap Wi-Fi and ensure the Wi-Fi button is switched ON to display available networks.
Connect to Wi-Fi network.
Once connected, go to the Home screen.
Tap on the Updater App to view assigned updates.
You will see ELD Complete 4.06.004
Tap Update/Install.
The update will begin to download. After about a minute, a box will pop up asking if you would like to install this application.
Tap Next, and then Install.
The installation takes around a minute. Once it’s successfully completed, you will see “App Installed.”
Tap Open.
A message will appear stating “ELD has not been configured.
Tap Configure to proceed.
Once the configuration is complete, you will see “ELD has been successfully configured.”
Tap OK to finish.
After all updates are completed, restart the tablet by pressing and holding on the Power button and then tap Reboot.
After the tablet reboots, be sure to go back into the Settings app to disable Wi-Fi (Settings > Settings Password = gpsield > Tap on Wi-Fi > turn switch OFF).
If you encounter any issues while updating the tablet, please contact Support.