The AIR II Auxiliary Camera kit contains one mount base with adhesive, one mount cover, three mounting screws (self-tapping), two mount side screws, and one allen key.
Installation Overview
The following steps provide an overview of the installation process:
Installation preparation.
Mounting & assembly.
Wire Connections.
Verifying installation.
Installation Steps
1. Installation preparation.
Determine mounting location.
Clean the mounting surface of the vehicle to ensure strong adhesion.
2. Mounting & assembly.
Peel the film off the adhesive pad (located on the bottom of the mount base).
Secure the mount base to the vehicle’s surface, ensuring it is properly positioned to set the camera’s viewing direction.
Use the three self-tapping screws to secure the mounting base to the vehicle, inserting the screws through the three holes at the bottom of the base.
Insert the aux camera into the mounting base.
Place the mount cover over the mount base, ensuring the camera lens is centered and sits flush with the cover’s opening.
Use the side screws to secure the mount cover to the mount base.
Use the provided hex tool to tighten the side screws on the mount.
3. Wire connections.
Connect the auxiliary camera cable to the auxiliary camera pigtail.
Route the auxiliary camera cable through the vehicle, securing and concealing the wire to protect it from damage.
Connect the other end of the auxiliary camera cable to the main camera, then tuck, zip-tie, and conceal any excess wiring.
4. Verifying installation.
Connect your smartphone to the camera’s Wi-Fi. The Wi-Fi SSID will match the main camera’s serial number.
Start the installation test.
On the auxiliary camera setup page, adjust the camera to the correct orientation.
Verify that the live video stream displays the auxiliary camera in the correct upright position.